Bring Your Timber Back to Life
From Queenslander verandahs to modern hardwood decks, we clean, sand and recoat to protect against sun, rain and foot traffic — leaving a rich, even finish that elevates your outdoor living.
Specialists in exterior timber care
We service Brisbane, Logan and Moreton Bay — up to the Sunshine Coast and down to the Gold Coast — restoring decks, stairs, handrails, screening and pergolas. Our systems are matched to timber species and exposure for longer‑lasting beauty.
What we do for decks & exterior timber
Deep Clean & Wash
Soft‑wash or pressure clean with timber safe detergents; mould and tannin removal.
Sand & Surface Prep
Machine sanding (coarse to fine), edge details and dust control for even absorption.
Oil, Stain or Clear
Penetrating oils, semi‑transparent stains or clear elastomeric finishes matched to use.
Minor Repairs
Board swaps, countersinking/screw reset, filling and re‑fixing where required.
Teak & Specialty
Marine‑grade products for high‑exposure areas, stairs and handrails.
Maintenance Plans
Seasonal washdowns and re‑coats scheduled to maximise life and colour.
Popular tones & sheen levels
Natural/Clear
Enhances grain with minimal colour; great for fresh hardwoods.
Warm Cedar
Adds rich warmth while keeping grain visible.
Jarrah/Merbau Deep
Deeper tone to match classic QLD hardwoods and screening.
Matte to Satin
Choose from low‑sheen natural to satin for easy cleaning.
UV‑Max Systems
Extra UV blockers for north/west‑facing or coastal exposures.
Low‑Slip Options
Micro‑beads for steps and ramps while keeping a refined look.
Proven restoration sequence
How to keep your deck looking its best
Dry & Cure Times
Touch‑dry ~1–4h; light use ~24h; avoid heavy furniture for 72h. Times vary by product and weather.
Cleaning
Soft broom + mild detergent; avoid harsh chemicals and high‑pressure close to grain.
Re‑coat Intervals
Typically every 6–18 months depending on exposure; we’ll advise a schedule.
Common questions about deck restoration
Do you strip old coatings back to bare timber?
Yes — we mechanically sand to a clean, even surface where required. Some film‑forming coatings may need chemical assist; we’ll assess on site.
Oil, stain or clear — what should I choose?
Oils penetrate and are easy to maintain; stains add tone while showing grain; clear elastomerics give a subtle sheen with strong UV protection.
How do you handle weather changes?
We schedule around rain and dew points, and pause if conditions fall outside spec. We’ll keep you updated daily.
Is your work warranted?
Yes — workmanship is covered by a 10‑year warranty. Maintenance timing affects coating life; we’ll provide care notes.
Give your timber the Uplift finish
Book a consultation — we’ll take it from there.
Check Out Our Other Services
From Epoxy Floors to Colour Consultation, we bring the same luxury touch to every project.
View Services